To set up a Tour Golf Towel on a stand bag, thread one end of the towel through the centre slit until the slit sits at the top of the bag anchor point, position the towel so equal lengths hang on each side, then wet one half and leave the other dry. The whole setup takes under two minutes and produces a stable wet and dry zone system that stays in place through a full walking round without adjustment. The most common mistake is clipping the towel at one end rather than threading through the slit, which wastes the wet and dry zone system entirely.
What You Need Before You Start
A Tour Golf Towel with a reinforced centre-slit and hanging loop. A source of water before the round: a tap near the practice green, a water bottle, or a water feature near the first tee. Nothing else.
The bag itself needs one of the following at the top section: a fabric loop or reinforced tab just below the carry handle, an alignment stick in the top club divider, or two or three accessible club necks near the top of the bag. Most modern stand bags have all three. Any one of them is sufficient.
Step-by-Step: Centre-Slit Setup on a Stand Bag
- Lay the towel flat and locate the centre slit. On the PINSEEKER Tour Golf Towel, the slit is reinforced and positioned at the exact midpoint of the 40x100cm length, with a hanging loop above it.
- Push the hanging loop over an alignment stick, the top club in your bag (a rescue or fairway wood works well), or your bag's fabric loop below the carry handle. The loop should sit over the anchor point with the slit immediately below.
- Feed the lower section of the towel through the slit from below, pulling upward until the slit tightens against the loop. This creates the lark's head attachment: the weight of both halves pulls the slit closed against the anchor point.
- Check that both halves hang evenly. The towel should hang clear of the bag side and ground, with both ends accessible from either side of the bag without pulling the bag forward.
- Wet one half before you leave the practice area. Dampen the active cleaning section thoroughly but not to the point of dripping: the goal is absorbent and damp. The other half remains dry.
The lark's head knot formed by threading the towel through its own slit tightens as weight is applied. It does not loosen mid-round. If your towel is slipping at the anchor point, the most common cause is the anchor being too smooth or narrow: switch from the bag's carrying handle strap (often smooth nylon) to a club neck or alignment stick, which provides a rougher surface and wider profile for the loop to grip against.
Setting Up the Wet and Dry Zones
The wet side is the active cleaning section: use it on clubfaces after every shot, on the ball before putting, and on grip tops in light drizzle.
The dry side is the finishing section: use it after cleaning to remove excess moisture from the face before replacing the club. A club returned to the bag with surface moisture will transfer it to grip tape over repeated rounds.
Set up the wet and dry zones before the first tee, not on it. Once you start using the towel before establishing which side is which, the system stops working and both halves end up wet.
Positioning for Access Mid-Round
On a stand bag, the towel should sit on the bag's front face or right side, not tucked behind the bag. The goal is to reach the towel without turning the bag or pulling it forward from the ground. After every iron shot, you should be able to grab the correct zone in one motion while the club is still in your hand.
Position the wet side facing outward for fastest access. The dry side on the reverse is accessible deliberately after cleaning, not in the same motion.
Common Setup Mistakes
- Clipping at one end instead of threading. Threading through the slit is the method. Clipping the towel at one corner gives you half the surface and no wet and dry zone distinction.
- Setting up too late. The system needs to be in place before you reach the first tee. Setting up on the course means making the switch mid-round, which disrupts the routine.
- Wrong anchor point. A smooth strap allows the hanging loop to slide. A club neck or alignment stick holds reliably.
- Forgetting to wet the cleaning side. A dry towel in both sections is not a cleaning system. Set the wet zone before you walk to the first tee.
For the centre-slit attachment method explained in full, including how the lark's head knot works and why it does not slip, see what is a centre-slit golf towel. For on-course cleaning technique that gets the most from this setup, see how to keep your golf clubs clean on the course.
